Carrier Access Access Navigator User Manual

set ip gateway <address>

Enables and disables the downloading of configuration data to the remote terminal. The 
default setting is “on”, which enables the Access Navigator to automatically download 
configuration settings to the remote Access Bank II over the Carrier Access FDL 
management channel. This setting allows configuration changes to be sent immediately 
and provides flow-through provisioning when a remote Access Bank II is installed and 
powered up. When turned off, the Access Navigator will not download any 
configuration data.

To speed up the provisioning of remote services, temporarily turn off 

remote configuration downloading to the Access Bank II. When finished, turn 
remote configuration on again, and the Access Navigator will download all 
changes at once. Downloading to each Access Bank II can take up to one 
minute. The status remote command will report “FDL tx in progress” during 
transmission and “FDL in service as CA FDL” when transmission is complete.

Use the show remote command to display current settings in the 

Access Navigator data base. 

The set remote config command only affects your ability to write 

configuration settings to the remote Access Bank II data base. You can always 
use the read remote command to display the actual remote configuration 
settings whenever the Access Bank II is connected to the Access Navigator via 
the DS1 link and Carrier Access FDL management is selected. (See Provision 
Remote Access Bank II on 

.) 

Level 2 (operator)

Gateway addresses have the format xxx.xxx.xxx.xxx, 
where each xxx is a decimal number between 0 and 255. If a 
gateway address is not used, you must enter 

 for the 

gateway address.