Klark Teknik DN9652 User Manual
Chapter 1: Getting Started
DN9650/DN9652 Network Bridge
4
Operator Manual
Configuring the unit for the first time
Important:
Before you use the unit for the first time, you must configure your computer
with the IP address and netmask to suit the range used by the DN965X.
Before you use the unit for the first time, you must configure your computer
with the IP address and netmask to suit the range used by the DN965X.
Before you can use the DN965X as a network bridge, you must first configure it by
choosing the type of network module card(s) that are fitted in the unit and then setting
them up. Configuration involves connecting the DN965X to a computer running an
up-to-date web browser. To make sure your computer is compatible with the DN965X,
you will need to change its IP address and netmask. For more information on
configuration, see Chapter 5 "Configuring the DN965X" on page 17.
choosing the type of network module card(s) that are fitted in the unit and then setting
them up. Configuration involves connecting the DN965X to a computer running an
up-to-date web browser. To make sure your computer is compatible with the DN965X,
you will need to change its IP address and netmask. For more information on
configuration, see Chapter 5 "Configuring the DN965X" on page 17.
>> To connect the DN965X to a computer and then open its configuration
menu in the web browser
menu in the web browser
1
Connect an Ethernet cable to the CONTROL socket on the rear panel of the
DN965X and then to the Ethernet port of your computer.
DN965X and then to the Ethernet port of your computer.
Connecting a DN965X to a computer
2
Switch on the DN965X and your computer. (Note the default IP address of the
DN965X, which is displayed on its LCD screen during power up.)
DN965X, which is displayed on its LCD screen during power up.)
3
To make sure your computer is compatible with the DN965X, we recommend that
you change the IP address and netmask of your computer to 192.168.2.1 and
255.255.0.0, respectively; for instructions, refer to your computer’s help and
support information.
you change the IP address and netmask of your computer to 192.168.2.1 and
255.255.0.0, respectively; for instructions, refer to your computer’s help and
support information.
4
Open your computer’s web browser.
Note: Make sure your web browser is up-to-date.
5
In the web browser’s address bar, type
in the following default IP address
(displayed on the unit’s LCD screen
during power up) and then press
ENTER:
in the following default IP address
(displayed on the unit’s LCD screen
during power up) and then press
ENTER:
“http://192.168.10.10”
Ethernet cable
Laptop PC/Mac
CONTROL
connector
connector
Typical browser address bar