Asante Technologies FR1104-G User Manual
Chapter 2. Hardware Details
Asanté FriendlyNET FR1104-G
User’s Manual
8
2.2
R
EAR
P
ANEL
Looking at the router from the rear, the following connectors are available.
Port Function
Description
5 VDC
Power Input
Plug in the Asanté FR1104 external power module
rated at 5 VDC, 1.5 A (minimum).
rated at 5 VDC, 1.5 A (minimum).
1 through 4
LAN Ports
Plug in a cable from your computer to one of these
ports. 10/100BaseT Fast Ethernet (RJ-45 connector).
Auto-Uplink™ supports any standard or “crossover”
cable. These computers are on your local area
network (LAN).
ports. 10/100BaseT Fast Ethernet (RJ-45 connector).
Auto-Uplink™ supports any standard or “crossover”
cable. These computers are on your local area
network (LAN).
Internet
Internet
Plug in a cable from your cable/DSL modem to this
port. 10/100BaseT Fast Ethernet (RJ-45 connector).
Auto-Uplink supports any standard or “crossover”
cable. Sometimes this port is also called the wide
area network (WAN).
port. 10/100BaseT Fast Ethernet (RJ-45 connector).
Auto-Uplink supports any standard or “crossover”
cable. Sometimes this port is also called the wide
area network (WAN).
Wireless Antenna
Replaceable
antenna (RP-SMA connector).
Computers wirelessly connected to the router are
known as the wireless LAN (WLAN).
known as the wireless LAN (WLAN).
The LAN (numbered 1–4) and Internet ports are wired according to standard 100BaseTX
standards:
Pin Number
Signal
Direction
1 TX+
Out
2 TX-
Out
3 RX+
In
4
—
5 —
6 RX-
6 RX-
In
7 —
8 —
8 —
Tip: Need to connect more than 4 wired computers or devices to this router? Use a Category 5
UTP Fast Ethernet cable and connect it from your switch (or hub) to this router. The router’s Auto-
Uplink feature will automatically configure the port for “uplink” (MDI).
UTP Fast Ethernet cable and connect it from your switch (or hub) to this router. The router’s Auto-
Uplink feature will automatically configure the port for “uplink” (MDI).