Hitachi CP-X2521WN User Manual

45

Using ▲/▼ buttons switches the standby mode setting between 

NORMAL and SAVING. 

NORMAL Ù SAVING

When SAVING is selected, the power consumption in the standby 

mode is lowered with some functional restriction as below:
• When SAVING is selected, the RS-232C communication control 

except to turn the projector on and the network function are disabled 

while the projector is in the standby mode. If the COMMUNICATION 

TYPE in the COMMUNICATION menu is set to NETWORK 

BRIDGE, all of the RS-232C commands are disabled (

59).

• When SAVING is selected, STANDBY setting of AUDIO SOURCE 

(

46) is invalid, and no signal is output from AUDIO OUT port in 

the standby mode.

• When SAVING is selected, STANDBY setting of MONITOR OUT 

is invalid, and no signal is output from MONITOR OUT port in the 

standby mode.

While the image signal from the input port chosen in step (1) is 

projected, the image signal from the input port selected in step (2) is 

output to MONITOR OUT port.
(1) Choose a picture input port using ▲/▼ buttons.

Choose STANDBY to select the picture  

output in the standby mode. 

(2)  Select one of the COMPUTER IN ports  

using ◄/► buttons. 

Select OFF to disable the MONITOR OUT  

port for the input port or standby mode  

chosen in the step (1).

• You cannot select COMPUTER IN2 for COMPUTER IN1, and vice 

versa.
• If you have changed the setting of STANDBY, it applies only to 

the current standby mode, NORMAL or SAVING, selected under 

STANDBY MODE, without changing the setting of the other mode. 

The factory settings are as follows:

- COMPUTER IN1 for the NORMAL mode of STANDBY MODE
- OFF for the SAVING mode of STANDBY MODE 

SETUP menu