3M 40800 User Manual
25
12-OPERATION
12.1 Operator's Correct Working Position and
Operational Flow (Figure 12-1).
Once the box has been fi lled, close its top fl aps and
push it between the top and bottom drive belts.
Always keep hands in position as shown in
push it between the top and bottom drive belts.
Always keep hands in position as shown in
Figure 12-2.
The box will be automatically sealed with adhesive
tape on the top and bottom box seams. Then the
box will be expelled on the exit conveyor.
The box will be automatically sealed with adhesive
tape on the top and bottom box seams. Then the
box will be expelled on the exit conveyor.
12.3 Starting Production
After having adjusted the machine according to the
box dimensions (height-width), let the machine run
without cartons and check its safety devices. Then
start the working cycle.
After having adjusted the machine according to the
box dimensions (height-width), let the machine run
without cartons and check its safety devices. Then
start the working cycle.
12.4 Tape Replacement and Threading
Skill 1 - Operator
See Manual 2:
AccuGlide™ 3 Taping Heads -
2 Inch.
Press the
LATCHING EMERGENCY STOP BUTTON.
LATCHING EMERGENCY STOP BUTTON.
12.5 Box Size Adjustment
Repeat all the operations shown in
Repeat all the operations shown in
Section 11 - Set-Up and Adjustments.
12.6 Cleaning
Before carrying out any cleaning or maintenance
operation stop the machine by Pushing the OFF (O)
switch on the main and disconnect the electric power
operation stop the machine by Pushing the OFF (O)
switch on the main and disconnect the electric power
(Figure 12-3).
12.8 Safety Devices Inspection
1 Taping units blade guard
2 Latching emergency stop button
3 STOP/OFF (O) main switch
Operator Qualifications
1 Tape loading and threading
1
2 Tape web alignment
1
3 Adjustment of one way tension roller
1
4 Adjustment to box size (H and W)
1
5 Top fl ap compression rollers
1
6 Adjustment of tape applying spring
1
7 Conveyor bed height adjustment
1
8 Special Adjustment-Changing tape leg length 2
9 Special Adjustment-Column re-positioning
9 Special Adjustment-Column re-positioning
2
12.7 Table of Operation Adjustments -
12.2 Starting the Machine
Important:
Important:
Before starting the machine, verify that
no tools or other objects are on the conveyor bed.
Push the main switch ON (I) after the EMERGENCY
BUTTON is released
(Figure 12-3).
2011 June
700a-NA
Figure 12-3
Figure 12-1
•
To reduce the risk associated
with sharp blade hazards:
−
Keep hands and fi ngers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
WARNING
Figure 12-2
Hand
position