Epson EL 33 User Manual

On your system, diskette drive A is the 3.5-inch highdensity

drive installed in the lower drive bay on your system. You may

also have another drive of a different size or capacity; this is

drive B. Check the settings for both drives and correct them if

necessary.

If you add a diskette drive and want to reassign the top

drive as drive A, you must change jumpers J17 through J20,

as described in Chapter 3. Then run SETUP to reassign drive
types.

The SETUP program lets you select the type of hard disk

drive(s) installed in your computer. If your system was

configured for you, the hard disk drive type has been preset.

To set the hard disk drive type, follow these guidelines:

If your system does not have a hard disk, select

Not Installed for Hard Disk 1 and Hard Disk 2.

If your computer came with an Epson-installed hard disk

drive, you need to define your own drive type. For more

information, see ‘Defining your own drive type” on

page 1-14.

If you have installed another type of hard disk drive, you

need to select the drive type number that matches your

drive.