Printronix T4204 User Manual

 195

For the operator-correctable faults, follow the suggested corrective action 
under the solution section of the table. After correcting the displayed fault, 
press the CLEAR key to clear the error message and status indicator and 
resume printing. If the fault message reappears, contact your authorized 
service representative.

NOTE: The 

Maintenance Manual provides more detailed information and 

procedures for resolving fault conditions. However, many of the 
procedures described there must be performed only by your 
authorized service representative

.

If a fault is not correctable by the operator, the fault message is followed by an 
asterisk (*). This usually indicates that an authorized service representative is 
needed. You may try two steps to clear the fault before calling your authorized 
service representative:

1.

Set the printer power switch to O (off), wait 15 seconds, then turn the 
printer on again. Run your print job again. If the message does not 
appear, it was a false indication and no further attention is required.

2.

If the message reappears, press the CLEAR key. If the message goes 
away, it was a false indication and no further attention is required. If the 
message reappears, call your authorized service representative.