SATO D512 User Manual

SATO D508/D512 Operator Manual

 

 Page 5-5

The High Speed Serial Interface is an factory installed option that must be installed in the 
printer at the time of order. The D508 / D512 recognizes the RS-232 interface automatically.

General Specifications
Asynchronous ASCII

Half-duplex communication

Ready/Busy Hardware Flow Control
Pin 20, DTR Control
Pin 4, RTS Error Condition

X-On/X-Off Software Flow Control
Bi-Directional Communication 

Data Transmission Rate

9600, 19200, 38400, 57600 bps 

Character Format

1 Start Bit (fixed)
7 or 8 data bits (selectable)
Odd, Even or No Parity (selectable)
1 or 2 Stop bits (selectable)

Connector

DB-25S (Female)

Cable

DB-25P (Male), 50 ft. maximum length. For cable

 

configuration, refer to Cable Requirements appropriate to 

 

the RS232C protocol chosen.

Signal Levels

High = +5V to +12V 
Low = -5V to -12V