SATO D512 User Manual
SECTION 5: INTERFACE SPECIFICATIONS
Page 5-8 SATO D508/D512 Operator Manual
5.7 WIRELESS LAN INTERFACE (802.11 B/G)
The wireless print server provides easy printer interface with 802.11G Wi-Fi compliant networks
free of wired connections. Each printer is shipped with an integrated driver and interface
installed. The driver must be loaded onto the host computer and configured to run one of the
supported protocols.
free of wired connections. Each printer is shipped with an integrated driver and interface
installed. The driver must be loaded onto the host computer and configured to run one of the
supported protocols.
Wired Equivalent Privacy
Range
100m indoors, 300m outdoors
Protocols
TCP/IP, IPX/SPX, Direct Mode IPX/IP, DLC/LLC, NetBEUI,
NetBIOS/IP
NetBIOS/IP
Protocol
Status3 return
Protocol for Driver (cyclic response mode)
Protocol for Driver (ENQ response mode)
Status5 return
Protocol for Driver (cyclic response mode)
Protocol for Driver (ENQ response mode)
Status5 return
IP Address
0.0.0.0 to 255.255.255.255
Subnet Mask
0.0.0.0 to 255.255.255.255
Gateway Address
0.0.0.0 to 255.255.255.255
Communication Mode
802.11 Ad hoc, Ad hoc, Infrastructure
SSID
Channels
Channels
01 to 11
SPECIFICATIONS
Variable Data Rates
54, 11, 5.5, 2 and 1 Mbps
Frequency Band
2.4 GHz ISM Band
128 bit, 64 bit (compatible with 40bit), WPA, none
Sensitivity
(typ, AAWGN, 8E-2 PER): -91dBm at 1Mbps, -88dBm at 2
Mdps, -87dBm at 5.5Mbps, 84dBm at 11Mbps.
Mdps, -87dBm at 5.5Mbps, 84dBm at 11Mbps.
Optional alphanumeric character string (up to 32 characters)
DIP SWITCH SETTINGS
The DIP switches serve to initialize the configuration saved on the Wireless-LAN board, print
the configuration, and make a self-diagnosis. To communicate with the host,set the communi-
cation mode by through switches 5 and 6, then set the remaining switches to the OFF position.
the configuration, and make a self-diagnosis. To communicate with the host,set the communi-
cation mode by through switches 5 and 6, then set the remaining switches to the OFF position.
Print of configuration and self-diagnosis are operable only on the screen after turning on the
printer. Ensure all switches are in the OFF position when operating the printer.
printer. Ensure all switches are in the OFF position when operating the printer.
SWITCH
SETTING
1
Reserved for test use only (setup prohibited).
2
LAN board EEPROM initialization (initialize configura-
tion).
tion).
3
Print configuration details on a label (diagnostic & config-
uration).
uration).
4
Print a self-diagmosis of the board onto a label (wireless
mode).
mode).
NOTE: The communication mode may be set within the printer’s Interface Mode. Go to [Com-
munication] of the Interface Mode to enable setup by either the DIP switches or through the
Interface Mode.
munication] of the Interface Mode to enable setup by either the DIP switches or through the
Interface Mode.