KYOCERA C5025N User Manual
Using the Operator Panel
2-30
ADVANCED OPERATION GUIDE
8
Press
U or V to scroll through the following communication modes:
•
Nibble (high)
•
Auto
•
Normal
•
High Speed
9
When the desired communication mode is displayed, press [OK]
([ENTER]).
([ENTER]).
10
Press [MENU] to exit the menu selection.
Changing Serial Interface Parameters (FS-C5030N only)
NOTE:
This section applies to the printer having the optional serial
interface board kit (IB-11) installed.
You can confirm or change the serial interface parameters including baud
rate, data bits, stop bits, parity, and protocol. These parameters must
match those of the computer’s serial interface.
rate, data bits, stop bits, parity, and protocol. These parameters must
match those of the computer’s serial interface.
1
Press [MENU].
2
Press
U or V repeatedly until Interface > appears.
3
If the interface is other than serial, press
[OK] ([ENTER]). A blinking question mark
(?) appears.
[OK] ([ENTER]). A blinking question mark
(?) appears.
4
Press
U or V repeatedly until Serial
appears.
5
Press [OK] ([ENTER]) again.
6
Press
Z. One of the following serial parameters is indicated (Baud rate
for example).
Interface
? Parallel
Interface
? Serial