HP (Hewlett-Packard) 9050MFP User Manual
ENWW
Software, computer, and product interface problems 163
Software, computer, and product interface problems
Situation
Solution
A page fails to print.
Set
PRINT PS ERRORS=ON
, and then send the job again to print a PS
error page. If this does not identify the problem, try turning off
Resource Saving
and
I/O Buffering
or try installing more memory
(see
A page prints with clipped
margins.
margins.
If the page margins are clipped, you might have to print the page at
300-dpi resolution or install more memory. Also try turning off
300-dpi resolution or install more memory. Also try turning off
Resource Saving
and
I/O Buffering
.
A PS error page prints.
●
Make sure the print job is a PS job.
●
Check to see whether your program expected you to send a setup
or PS header file to the MFP.
or PS header file to the MFP.
●
Check the MFP setup in your software application to make sure
that the MFP is selected.
that the MFP is selected.
●
Check cable connections to ensure that they are secure.
●
Reduce the complexity of the graphic.
●
Add available memory by turning on
Resource Saving
.
A text listing of PS
commands prints instead of
your PS print job.
commands prints instead of
your PS print job.
The control panel
PERSONALITY=AUTO
setting might have been
confused by a nonstandard PS code. Check the
PERSONALITY
setting
to see if it is set to
PS
or
PCL
. If it is set to
PCL
, set it to
PERSONALITY=AUTO
. If it is set to
AUTO
, set it to
PS
for this print job only.
When the job has printed, return the setting to
AUTO
.
Attempted to use a
disk-resident font, but the
MFP substituted a different
font.
disk-resident font, but the
MFP substituted a different
font.
If you are using PCL, print the PCL Font Page, and verify that the font
is on the disk. If you are using PS, print the PS Font Page and make
sure that the font is on the disk. If the font is not on the disk, use the
Device Storage Manager or the Macintosh-based HP LaserJet utility to
download the font.
is on the disk. If you are using PS, print the PS Font Page and make
sure that the font is on the disk. If the font is not on the disk, use the
Device Storage Manager or the Macintosh-based HP LaserJet utility to
download the font.
Auto setup did not
automatically set up the
MFP.
automatically set up the
MFP.
●
Set up the MFP manually by selecting
Configure
.
●
Select an alternate PPD (See
●
The PPD might have been renamed. If so, select the renamed
PPD (See
PPD (See
●
A network queue might be present.
Blank pages print.
●
Turn the MFP off and then back on.
●
Make sure the print cartridge is installed properly.
Cannot access Tray 2 or 3,
or Tray 4.
or Tray 4.
).