HP (Hewlett-Packard) L7300 User Manual

If you require printed confirmation that your faxes were successfully sent, follow these
instructions to enable fax confirmation before sending any faxes. Select either On Fax
Send or Send & Receive.
The default fax confirmation setting is Off. This means that a confirmation report is not
printed for each fax sent or received. A confirmation message indicating whether a fax
was successfully sent appears briefly on the control-panel display after each
transaction.

To enable fax confirmation
1. Press Setup.
2. Press Print Report, and then Fax Confirmation.
3. Press the right arrow button to select one of the following, and then press OK.

Does not print a fax confirmation report when you send and receive
faxes successfully. This is the default setting.

Prints a fax confirmation report for every fax you send.

Prints a fax confirmation report for every fax you receive.

Prints a fax confirmation report for every fax you send and receive.

If you choose On Fax Send or Send & Receive, and scan your fax to

send from memory, you can include an image of the first page of the fax on the
Fax Sent Confirmation report. Press Setup, press Fax Confirmation, and
then press On Fax Send again. Select On from the Image on Fax Send
Report menu.

You can configure the device so that it automatically prints a report when there is an
error during transmission or reception.

To set the device to print fax error reports automatically
1. Press Setup.
2. Press Print Report, and then press Fax Error Report.
3. Press the right arrow button to select one of the following, and then press OK.

Prints whenever a fax error occurs. This is the default setting.

Does not print any fax error reports.

Prints whenever a transmission error occurs.

Prints whenever a receiving error occurs.

Chapter 8

84

Fax (some models only)