HP (Hewlett-Packard) 5000 User Manual
Removal and Installation
8-2
HP DesignJet 5000 Series Printers Service Manual
Introduction
This chapter is a step by step guide to the removal and installation of the key components
in the Printer. You may find it useful to tick off the steps as they are performed. Use the
illustration at each procedure to identify the parts referred to in the text.
in the Printer. You may find it useful to tick off the steps as they are performed. Use the
illustration at each procedure to identify the parts referred to in the text.
The procedures appear in order of removal. So the whole machine can be stripped down
by starting at the beginning of this chapter and working through the subsequent
procedures.
by starting at the beginning of this chapter and working through the subsequent
procedures.
NOTE
Before using this chapter to remove and/or replace a component
or assembly, always make sure that you have performed the
relevant service test for each component as described in 4,
Service Tests and Utilities. If the test passes you will not need to
replace the component.
or assembly, always make sure that you have performed the
relevant service test for each component as described in 4,
Service Tests and Utilities. If the test passes you will not need to
replace the component.
NOTE
To install a component perform the removal procedures in
reverse order unless a specific installation procedure is provided.
reverse order unless a specific installation procedure is provided.
NOTE
After removing and/or replacing a component, the relative
procedure will state whether any calibrations and/or tests are
required (5, Service Calibrations).
procedure will state whether any calibrations and/or tests are
required (5, Service Calibrations).
Safety Precautions
(Safety symbols - Immediately after the table of contents.)
Review WARNING and CAUTION symbols and instructions before you service the
Printer. Follow these warnings and cautions for your protection and to avoid damaging
the Printer.
Printer. Follow these warnings and cautions for your protection and to avoid damaging
the Printer.
WARNING
Serious shock hazard leading to death or injury may result if you
do not take the following precautions:
do not take the following precautions:
Ensure that the ac power outlet (mains) has a protective earth
(ground) terminal.
(ground) terminal.
Switch the plotter off, and disconnect it from the power source
prior to performing any maintenance.
prior to performing any maintenance.
Prevent water or other liquids from running onto electrical
components or circuits, or through openings in the module.
components or circuits, or through openings in the module.