HP (Hewlett-Packard) 5000 User Manual
Removal and Installation
8-42
HP DesignJet 5000 Series Printers Service Manual
Tensioner Assembly
Removal
WARNING
Switch off the Printer and remove the Power Cord.
NOTE
Refer to the table on Page 8-4 for information on screw types.
1. Remove the Left Hand Cover - Refer
2. Remove the Right Hand Cover - Refer
3. Remove the 5.5 mm nut from the left
hand side of the Printer that attaches
the Encoder Strip to the Spring Clip.
the Encoder Strip to the Spring Clip.
TIP
The next step is performed
by putting pressure on the
Spring Clip as shown.
by putting pressure on the
Spring Clip as shown.
4. Release the Encoder Strip from the
retaining pin on the Spring Clip.
1. Apply Pressure
2. Release Encoder Strip