HP (Hewlett-Packard) 5000 User Manual
Removal and Installation
8-46
HP DesignJet 5000 Series Printers Service Manual
Carriage Assembly and Belt
NOTE
Please be very careful when handling the Encoder Guide at the rear
of the Carriage Assembly. If you break the Encoder Guide, a spare
one is included in this kit. To replace it, remove the 2 T-8 screws at
the rear of the Carriage and install the new Encoder Guide.
of the Carriage Assembly. If you break the Encoder Guide, a spare
one is included in this kit. To replace it, remove the 2 T-8 screws at
the rear of the Carriage and install the new Encoder Guide.
Removal
WARNING
Switch off the Printer and remove the power cord.
1. Remove the Left Hand Cover - Refer
2. Remove the Right Rear Cover - Refer
3. Remove the Right Hand Cover - Refer
4. Remove the Tensioner Assembly -
5. Pull out Printhead Cleaner Carriage.
Be careful not to break the Encoder
Guide. If necessary, it can be replaced
by the spare one by removing the
2 T-8 screws.
Guide. If necessary, it can be replaced
by the spare one by removing the
2 T-8 screws.