HP (Hewlett-Packard) 5000 User Manual
Removal and Installation
8-57
HP DesignJet 5000 Series Printers Service Manual
9. From the right-hand side, lift the
Tensioner Belt off the Scan-Axis
Motor.
Motor.
10. While supporting the Scan-Axis
Motor, remove 2 T-15 screws (Type
B).
B).
11. Lower the Scan-Axis Motor and
remove from the Printer.
Installation of the Scan-Axis Motor
NOTE
Before installation, clean and oil the Slider Rods using the User’s
Slider Rods Lubrification Kit (Refer to Page 9-8).
Slider Rods Lubrification Kit (Refer to Page 9-8).
WARNING
When installing the Encoder Strip, make sure it is inserted in the
Encoder Sensor on the rear of the Carriage Assembly.
Encoder Sensor on the rear of the Carriage Assembly.
Encoder Sensor
Insert Encoder Strip