Toshiba 5205 Series User Guide
52
Getting Started
Setting up your computer
5.375 x 8.375 ver 2.4.0
11
Replace the memory slot cover.
12
Replace the screws and tighten them.
13
Turn the computer over and reconnect any cables you
removed.
removed.
You can now continue setting up the computer. When the
operating system has loaded, you can verify that the
computer has recognized the additional memory.
operating system has loaded, you can verify that the
computer has recognized the additional memory.
If you are adding extra memory after setting up the computer,
verify that the computer has recognized it correctly as
described in
verify that the computer has recognized it correctly as
described in
.
Removing a memory module
1
Follow steps 1 through 7 in
.
2
Gently push the memory locks outward until the memory
module pops up.
module pops up.
3
Gently pull the memory module diagonally out of the
slot.
slot.
4
Complete the procedure by following steps 11 through 13
in
in
Checking total memory
When you add or remove memory, you can check that the
computer has recognized the change. To do this:
computer has recognized the change. To do this:
1
Click Start, then click Control Panel
2
Click Performance and Maintenance.
3
Click System.
4
The General tab view automatically appears and shows
total memory.
total memory.
If the computer does not recognize the memory
configuration, turn off the computer, remove the memory slot
cover, and make sure the memory module is seated properly,
as described in
configuration, turn off the computer, remove the memory slot
cover, and make sure the memory module is seated properly,
as described in