Emerson 225-600KVA User Manual

For attached systems (the cabinets bolt to each other) the cables can run internal to the cabinets 

and will be supplied.
For detached systems (the cabinets do not bolt to each other), the cables must be run outside the 

cabinets. The customer must supply all the interconnecting cables and hardware. See Table 8 for 

current ratings and recommended cable sizes.

For cabinets that have been ordered as connected or attached, the ground cables and hardware will be 

supplied. See Figure 18 for location of cabinet-to-cabinet grounding. 
For cabinets ordered as detached or stand-alone, customer must supply the cables and hardware. See 

Table 8 for current ratings and recommended cable sizes. See terminal detail drawings for location of 

ground busbar.

Each Liebert NX Battery Cabinet contains a Battery Interface Board (BIB). See 3.0 - Installation 

Drawings. All cabinets in a system must have their Battery Interface boards connected in series. See 

Figure 9 for battery cabinet details

The CAN cables must be two, twisted pair, shielded 18AWG (Belden 9156 or equivalent). All 

interconnecting cables and hardware for connected and attached cabinets will be provided.

Risk of improper installation. Can cause equipment damage.
During system commissioning, Emerson

®

 Network Power Liebert Services will set the 

jumpers on the EIB and the BIB. If another battery cabinet is added to the system after 

commissioning, it is imperative that Liebert Services reset the jumpers on the EIB board and 

the BIB board.

NOTE
Care must be taken to route the control cables away from high voltage cables or busbars.

Ext. Interface 

Board (EIB)

TB3

Bat. Interface 

Board (BIB)

TB1154

Bat. Interface 

Board (BIB)

TB1154

CAN Cable

CAN Cable