MGE UPS Systems AmpMeter PDU User Manual

 

 

3. Operations 

This test validates that the unit is able to contact and log onto the specified FTP server, download the firmware 
file and verify that the firmware file is valid for this unit. 

Press 

.  

The SNTP configuration page is used for setup and maintenance of SNTP support. 

Enter the IP address in the primary and/or secondary address field and press 

. 

The SNMP configuration page is used for setup and maintenance of all settings required to enable SNMP 
support as well as access to the trap configuration pages.  For additional information on SNMP support and 
detailed descriptions of available traps, see on page 34. 

NOTE:  Traps are generated according to a hierarchical architecture; i.e. if a Tower Status enters a trap 
condition, only the Tower Status trap is generated.  Infeed and Outlet Status traps are suppressed until the 
Tower Status returns to Normal. 

Select 

or 

from the drop-down menu and press 

. 

Enter the community string in the appropriate field and press 

.  

Community strings may be 1 to 24 characters 

Enter a trap timer value in the Error Trap Repeat Time field and press 

. 

The Error Trap Repeat Time value may be 1 to 65535 (in seconds). 

Enter an IP address in the appropriate Trap Destination field and press 

. 

Click on the 

 link. 

On the subsequent Tower Traps page, select or deselect the desired traps and press 

. 

Click on the 

 link. 

On the subsequent Input Feed Traps page, select or deselect the desired traps and press 

. 

For Load traps, enter a maximum load value for the infeed in the High Load Threshold field and press 

. 

The High Load Threshold value may be 0 to 255 (in amperes). 

Page 16 - 301-0399-3 Rev B.