MGE UPS Systems EX30 User Manual

Pulsar EX : 51032306XT/BB

MGE UPS SYSTEMS

38

c 

take the "manual bypass" module  25 or

 31  and connect it behind Pulsar EX;

c 

screw on this module using the 2 screws

 24 ;

c 

plug the cable  26  into the connector  12

on Pulsar EX;

c 

close the battery circuit-breaker  7  on

Pulsar EX (as well as the circuit-breakers
 32  on the Pulsar EXB battery extension
modules if fitted): "l" position;

c 

with the "manual bypass" switch  28  set

to "BY-PASS", depress the button  3  ;

c 

check after 15 seconds that Pulsar EX

has started properly and that the following
indications are obtained:

c 

if the indicator lights are in a status other

than that indicated, do not switch the "manual
bypass" and contact our after-sales service;

c 

switch the "manual bypass"  28  from the

"BY-PASS" position to the intermediate
position (see figure 10).
The following indications are obtained:

to

off

intermittent beeps

!

-

+

%

-

+

flashing

off/power on

flashing/operation on
               "manual bypass"

to

intermittent beeps

!

-

+

%

-

+

n/a

flashing/load in
              "automatic
              bypass"

off/power on

c 

switch the "manual bypass"  28  from the

intermediate position to the "NORMAL"
position: operation is now normal and the
following indications are obtained:

!

-

+

%

-

+

to

indicate battery state

on/load energized

silence

off/power on
flashing/power off