MGE UPS Systems 1100 Tower User Manual

3400723200/AC

- Page 31

Time that the connected equipment can operate on battery power if AC-input power 
fails.

Device on the front panel indicating the percent remaining backup time or the percent 
load.

Automatic UPS operating mode whereby the input-power voltage is increased if it drops 
below a value set in the personalization parameters, thus avoiding a battery discharge.

The UPS must be physically disconnected from the AC-input power.

Devices and systems connected to the UPS output.

Automatic UPS operating mode whereby the input-power voltage is decreased if it rises 
above a value set in the personalization parameters, thus avoiding a battery discharge.

Circuit breaker protecting the upstream distribution system against UPS faults.

The parameters for a number of UPS functions may be modified using the UPS Driver 
software to adapt UPS operation to user needs.

Pulsar Evolution has two programmable receptacles. They may be used for sequential 
start-up of protected equipment, shedding of non-critical loads during operation on 
battery power or management of operating priorities to provide the most critical devices 
with more backup time before battery power runs out. These receptacles may be 
programmed using the Solution-Pac software on the CD-ROM supplied with the UPS.

Receptacle that allows you to connect the equipment you want to protect.

For UPS connection to a computer via the serial port.

MGE UPS SYSTEMS safety, set-up and supervision software suite on the CD-ROM 
supplied with the UPS.

Uninterruptible Power Supply.

Communications software on the CD-ROM supplied with the UPS. It may be used to 
personalize the default settings.

For UPS connection to a computer via the USB port.