APC ACRP500 User Manual

To do the following, see “Home” on page 18:

•  View and clear alarms.

To do the following, see “Group” on page 18:

•  View the status of the group.
•  Set the number of units in the group.
•  Define the configuration type used by the group.
•  Set the cool setpoints. For the ACRP100 series and ACRP500 series only, set the humidify, 

dehumidify, and reheat setpoints.

•  Set the fan speed preference.
•  Set the cool, dehumidify, and reheat PIDs, and the humidify sensitivity band (ACRP100 series 

and ACRP500 series only).

•  Set the percentage of glycol in the group (ACRC500 series and ACRP500 series).

To do the following, see “Unit” on page 20:

•  View the status and properties of each unit.
•  Set unit delays.
•  Change the unit identification values.
•  Configure and control the modes.
•  Assign the type of alarm that will activate the output sensor.
•  Set the normal state of the input and output.
•  Reset the unit run hours alarms.
•  Set alarm threshold values.
•  Set service intervals.

To do the following, see “Logs” on page 24:

•  Access the event and data logs.
•  Set the interval and rotation for the data log.
•  Create data log graphs.
•  Configure Syslog settings.

To do the following, see “Administration: Security” on page 32:

•  Control Administrator, Device User, and Read-Only user access.
•  Configure RADIUS access, servers, and server secret.

To do the following, see “Administration: Network” on page 37:

•  Configure new TCP/IP settings for the cooling unit.
•  Select the port speed.
•  Identify the Domain Name System (DNS) Server and test the network connection to that server.
•  Define settings for the FTP server, SNMP, Control Console/SSH, and Web/SSL.

To do the following, see “Administration: Notification” .

•  Configure the actions to be taken based on an event’s severity level.
•  Configure SNMP Trap Receiver settings for sending event-based traps.
•  Define who will receive e-mail notifications of events.
•  Test e-mail settings.