APC 6739380EN/JC User Manual
6739380EN/JC -
Page 37
"Monitor" alphanumeric display
(cont.)
">" button
20
This button has a number of functions
depending on the displayed messages
(selection, negative response, etc.).
In "Monitor" multi-cubicles mode, this
button can also be used to select one
of the eight cubicles that may be
connected to the "Monitor" unit, in
which case any action on the control
panel and the messages or
measurements displayed concern only
the selected cubicle.
In the event the selected cubicle does
not respond, the following message is
displayed:
depending on the displayed messages
(selection, negative response, etc.).
In "Monitor" multi-cubicles mode, this
button can also be used to select one
of the eight cubicles that may be
connected to the "Monitor" unit, in
which case any action on the control
panel and the messages or
measurements displayed concern only
the selected cubicle.
In the event the selected cubicle does
not respond, the following message is
displayed:
CUBICLE NUMBER XX
UNAVAILABLE
In the event of no reply from the display
screen, the following message appears:
screen, the following message appears:
DISPLAY NUMBER XX
UNAVAILABLE
Which corresponds to a communications
fault.
fault.
In the event of invalid data, the
following message is displayed:
following message is displayed:
CUBICLE NUMBER XX
FAULT
Note:
◗
most functions may be directly
accessed. For example, when voltage
measurements are currently displayed,
it is possible to directly access current
measurements by pressing the "A"
button;
measurements are currently displayed,
it is possible to directly access current
measurements by pressing the "A"
button;
◗
in "Monitor" multi-cubicles mode, it is
possible to access the same
measurement in another cubicle by
simply pressing the ">" button. For
example, if the battery voltage of a
cubicle is currently displayed, it is
possible to directly display the battery
voltages of the other cubicles by
pressing the ">" button once for each
other cubicle.
measurement in another cubicle by
simply pressing the ">" button. For
example, if the battery voltage of a
cubicle is currently displayed, it is
possible to directly display the battery
voltages of the other cubicles by
pressing the ">" button once for each
other cubicle.
General display function organization
Lights 1 to 8
They light if maintenance is carried out
on a cubicle or if the communication
link with a cubicle breaks down.
on a cubicle or if the communication
link with a cubicle breaks down.
These lights are useful particularly in
multi-cubicle mode.
multi-cubicle mode.
Green lights
Only one of these lights is on at a time,
indicating the number of the cubicle
concerned by the current display.
Only one of these lights is on at a time,
indicating the number of the cubicle
concerned by the current display.
Red lights
These lights provide an indication on
system status by signaling alarms and
problems in the concerned cubicles.
These lights provide an indication on
system status by signaling alarms and
problems in the concerned cubicles.
Initial screen, display of general alarms
This is the normal display which systematically reappears
when the control panel has not been used for ten minutes.
when the control panel has not been used for ten minutes.
Alarm display and buzzer reset
Voltage measurements
Current measurements
Frequency and power measurements
Battery measurements
On/Off controls
Language, screen contrast and
buzzer volume settings
buzzer volume settings
Cubicle selection for display of measurements
(multi-cubicle mode only)
(multi-cubicle mode only)
Information on type of cubicle
(multi-cubicle mode only)
(multi-cubicle mode only)
Display configuration
V
+ –
!
A
W.Hz
*
*
*
V
to select
or answer
no
or answer
no
to confirm
or answer
yes
or answer
yes
*
to
set
set
to
confirm
confirm
to
confirm
confirm
*