APC 15000 RAID User Manual
Preface
007-5510-002
vii
Chassis Warning Label: Weight Hazard
• Do not lift the drive enclosure by the handles on the power cooling module (PCM); they are not
designed to support the weight of the populated enclosure.
Safety
Important
SGI InfiniteStorage 15000 drive enclosures must be always installed in SGI InfiniteStorage 15000
racks. SGI does not authorize or support the use of these drive enclosures in any standalone
benchtop or enclosure-on-enclosure stacking configuration.
racks. SGI does not authorize or support the use of these drive enclosures in any standalone
benchtop or enclosure-on-enclosure stacking configuration.
If this equipment is used in a manner not specified by the manufacturer, the protection provided
by the equipment may be impaired.
by the equipment may be impaired.
Warning
The SGI InfiniteStorage 15000 MUST be grounded before applying power.
Unplug the unit if you think that it has become damaged in any way and before you move it.
Caution
Plug-in modules are part of the fire enclosure and must only be removed when a replacement can be
immediately added. The system must not be run without all units in place. Operate the system with the
enclosure top cover closed.
immediately added. The system must not be run without all units in place. Operate the system with the
enclosure top cover closed.
• In order to comply with applicable safety, emission and thermal requirements no covers should be
removed.
• The drive enclosure unit must only be operated from a power supply input voltage range of 200 V
AC to 240 V AC.
• The plug on the power supply cord is used as the main disconnect device. Ensure that the socket
outlets are located near the equipment and are easily accessible.
Warning
To ensure protection against electric shock caused by HIGH LEAKAGE CURRENT (TOUCH
CURRENT), the SGI InfiniteStorage 15000 must be connected to at least two separate and
independent sources. This is to ensure a reliable earth connection.
CURRENT), the SGI InfiniteStorage 15000 must be connected to at least two separate and
independent sources. This is to ensure a reliable earth connection.
• The equipment is intended to operate with two (2) working PCMs. Before removal/replacement of
any module disconnect all supply power for complete isolation.
• A faulty PCM must be replaced with a fully operational module within 24 hours.