3M 10700 User Manual
21
Operation
(Continued)
3.
Once the box is pushed under the upper taping
head, the upper drive assembly actuator switch
is releases to lower the upper drive assembly to
descend onto the box top, as shown in
Figure 3-9, allowing the drive belts to convey the
box through the upper and lower taping heads for
application of the tape seals.
head, the upper drive assembly actuator switch
is releases to lower the upper drive assembly to
descend onto the box top, as shown in
Figure 3-9, allowing the drive belts to convey the
box through the upper and lower taping heads for
application of the tape seals.
4.
As the box is conveyed through the machine, the
centering guide switch is released causing the
centering guides to return to their full open
position, ready for insertion of the next box.
centering guide switch is released causing the
centering guides to return to their full open
position, ready for insertion of the next box.
5.
Once the box is conveyed from under the upper
taping head, the upper drive assembly descends
to its rest position, ready for insertion of the next
box.
taping head, the upper drive assembly descends
to its rest position, ready for insertion of the next
box.
At this point it is recommended that the centering
guides and upper drive assembly switches be
manually actuated to better understand their
functions. Depress the centering guide switch to
close the guides. Release the switch to open the
guides. Depress the upper drive assembly raising
switch to raise the upper drive assembly. Release
the upper drive assembly raising switch to lower the
drive assembly.
guides and upper drive assembly switches be
manually actuated to better understand their
functions. Depress the centering guide switch to
close the guides. Release the switch to open the
guides. Depress the upper drive assembly raising
switch to raise the upper drive assembly. Release
the upper drive assembly raising switch to lower the
drive assembly.
Figure 3-9—Box Conveyed Through Machine
Box Sealing
1.
Turn main air valve to (On).
Important: Before turning drive belts on, be sure
no tools or other objects are on the conveyor bed.
no tools or other objects are on the conveyor bed.
2.
Turn the switch on side of machine frame to start
drive belts.
drive belts.
3.
Feed boxes to machine. Always allow previous
box to exit machine BEFORE feeding next box.
box to exit machine BEFORE feeding next box.
4.
Turn air and electrical supplies "Off" when
machine is not in use.
machine is not in use.
5.
Reload and thread tape as necessary.
6.
Be sure machine is cleaned and lubricated
according to recommendations in "Maintenance"
section of this manual.
according to recommendations in "Maintenance"
section of this manual.
Note: Box drive motors are designed to run at
a temperature somewhat above ambient
room temperature. A motor may feel hot
to the touch during normal operation.
room temperature. A motor may feel hot
to the touch during normal operation.
•
To reduce the risk associated with pinches
and entanglement hazards:
−
Keep hands, hair, loose clothing, and jewelry
away from moving belts and taping heads
CAUTION
Machine or taping head adjustments are described
in "Adjustments" Section I for machine or Section
II for taping heads.
in "Adjustments" Section I for machine or Section
II for taping heads.