Adder Technology Adder TS4 User Manual

0 to 00% of the left of PC goes to 0 to 00% of PC-Primary
0 to 00% of the bottom of PC goes to 0 to 00% of PC4

0 to 00% of the right of PC-Primary goes to 0 to 00% of PC
0 to 00% of the bottom of PC-Primary goes to 0 to 00% of PC3

0 to 00% of the top of PC3 goes to 0 to 00% of PC-Primary
0 to 00% of the right of PC3 goes to 0 to 00% of PC4

0 to 00% of the top of PC4 goes to 0 to 00% of PC
0 to 00% of the left of PC4 goes to 0 to 00% of PC3

0 to 00% of the left of PC4 goes to 0 to 00% of PC3
0 to 00% of the right of PC4 goes to 0 to 00% of PC-Primary*

0 to 00% of the left of PC3 goes to 0 to 00% of PC
0 to 00% of the right of PC3 goes to 0 to 00% of PC4

0 to 00% of the left of PC-Primary goes to 0 to 00% of PC4*
0 to 00% of the right of PC-Primary goes to 0 to 00% of PC

0 to 00% of the left of PC goes to 0 to 00% of PC-Primary
0 to 00% of the right of PC goes to 0 to 00% of PC3

14  When all of the screen switching entries have been entered, click the OK 

button to return to the main window. Now choose the Serial Port on the 
primary computer to which the Adder TS4 serial cable is connected. 

15  On each client system, select the ‘Use this computer as a client’ radio 

button and enter the Screen Name (Hostname) of the primary system in the 
‘Name of Server’ field.

 

 Tip: To confirm that each client can see the server on the network, open 

the Windows Command Prompt and enter: ping <server hostname>. If the 
server can be seen, you will see replies to each outgoing message listed 
within the Command Prompt window. This test can also be performed from 
the server system to verify each of the clients. 

16  On every system you now need to determine when Synchrony should start. 

Depending on your access rights on each system, you can choose to launch 
Synchrony either:

  •  When the system first starts up, or
  •  When you log in. 
  Click the ‘AutoStart...’ button to display the following dialog:

 

 The application will check your current login status and present the 

available choices to you.

 Leave out these two 

entries if you don’t need to 
wrap around at each end

17  Click the relevant Install button and then click the Close button to return to 

the main window.

 

 You can now either click the Start button to begin each Synchrony session 

immediately or wait until each system is next restarted. The taskbar on the 
server system will begin greyed out 

 and will become coloured 

 once 

the client systems are located.

 

 In operation, as the mouse exceeds the boundary of one screen, the Adder 

TS4 unit should switch across to the next system and screen.