Cabletron Systems 9032848-02 User Manual
Verifying the Operation of the RoamAbout Access Point
3-10 Installing the RoamAbout Access Point
Verifying the Operation of the RoamAbout Access Point
The AP runs a series of self-tests on power-up and reports status using its LEDs.
When power-up begins, the following occurs:
The diagnostics take approximately 10 seconds to complete after power-up. Upon
successful completion of the diagnostics, the LED pattern shown in Figure 3-1 is
displayed.
successful completion of the diagnostics, the LED pattern shown in Figure 3-1 is
displayed.
If the AP fails to display the proper LED pattern, verify that you have correctly
installed the AP. If the AP still fails to display the LED pattern, refer to Chapter 5.
installed the AP. If the AP still fails to display the LED pattern, refer to Chapter 5.
Stage
Description
1
The firmware begins running diagnostics, initializes minimal hardware,
then sequentially turns LEDs 2 through 6 on and off.
then sequentially turns LEDs 2 through 6 on and off.
2
After LED 6 turns on and then turns off, the firmware completes its
diagnostics and hardware initialization. During this portion of the
diagnostics and hardware initialization, LEDs 2 through 7 flash on and
then off.
diagnostics and hardware initialization. During this portion of the
diagnostics and hardware initialization, LEDs 2 through 7 flash on and
then off.
3
The diagnostics then checks to see if the PC Card is properly inserted in
the AP. If a card is present, the PC Card Present LED lights.
the AP. If a card is present, the PC Card Present LED lights.