Intel 10/100 User Manual

44

C H A P T E R

3

set-ip <IPaddress>

Sets the IP address of the switch (technically, the switch’s SNMP
agent). If no IP address was previously set (default configuration), the
new value is saved in NVRAM and used immediately. Otherwise, the
new value is stored in NVRAM, but you must use the 

warm-reset

command or cycle the power for changes to take effect.

set-ip 192.001.001.064

 Device IP Address unchanged for this session

 Device IP Address change in the NVRAM OK

 The device NVRAM IP address will be:

            IP address   : 192.001.001.064

set-ip-conf <IPaddress> <netmask> <broadcast>

Sets the IP address, netmask (subnet mask), and broadcast IP address.
If no IP configuration was previously set (default configuration), the
new values are saved in NVRAM and used immediately. Otherwise,
the new values are stored in NVRAM, but you must use the

warm-reset

 command or cycle the power for changes to take effect.

SYS_console> set-ip-conf 192.1.1.64 255.255.255.0 192.1.1.255

 Device IP Address set for this session

 Device IP Address change in the NVRAM OK

 The device IP configuration in the next session will be:

            IP address   : 192.001.001.064

            IP netmask   : 255.255.255.000

            IP broadcast : 192.001.001.255

Displays the current state of the BOOTP process. By default, BOOTP
is disabled.

set-bootp {enable|disable}

Enables or disables BOOTP. With BOOTP enabled, the switch looks
for a BOOTP server at startup if no IP configuration is defined.

Displays the current SLIP address. By default, no SLIP address is
assigned.