Cabletron Systems 2E49-27R User Manual

OPERATION MODE (Toggle)

Allows the user to set the specified port to transmit and receive data 
separately (Standard) or simultaneously (Full Duplex). Set this field to 
one of the following values:

STANDARD ENET – The port is running at 10 Mbps (default) and 
either transmits data or receives data, but not both at the same time. To 
set Ethernet ports for Standard operation, refer to 

.

FULL DUPLEX – The port transmits and receives data 
simultaneously at 10 Mbps, thus enabling the port to effectively switch 
at 20 Mbps. To set Ethernet ports for Full Duplex operation, refer to 

.

LINK STATUS (Read-only)

Indicates whether there is a physical connection from this port to another 
10BASE-F device. One of the following values displays:

Link – There is a 10BASE-F link signal present; there is a valid 
physical connection from this port to another 10BASE-F device.

No Link – No 10BASE-F link signal present; there is no valid physical 
connection from this port to another 10BASE-F device.

PORT STATUS (Read-only)

Indicates whether the port was turned on or off administratively. One of 
the following values is displayed:

ENABLED – The port is turned on administratively.

DISABLED – The port is turned off administratively.

SET ALL PORTS (Toggle)

All ports (1 through 24) can be set at once to either STANDARD or 
FULL from this command field. To set ports, refer to 

Enabling or disabling ports from the Switch Configuration 
screen is described in