Cisco Systems 3130 User Manual
44-36
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 44 Configuring IP Multicast Routing
Configuring Optional Multicast Routing Features
Beginning in privileged EXEC mode, follow these steps to configure the switch itself to be a statically
connected member of a group (and enable fast switching). This procedure is optional.
connected member of a group (and enable fast switching). This procedure is optional.
To remove the switch as a member of the group, use the no ip igmp static-group group-address interface
configuration command.
configuration command.
Configuring Optional Multicast Routing Features
These sections describe how to configure optional multicast routing features:
•
Features for Layer 2 connectivity and MBONE multimedia conference session and set up:
–
(optional)
–
(optional)
•
Features that control bandwidth utilization:
–
(optional)
•
Procedure for configuring a multicast within a VPN routing/forwarding(VRF) table:
–
(optional)
Enabling CGMP Server Support
The switch serves as a CGMP server for devices that do not support IGMP snooping but have CGMP
client functionality. CGMP is a protocol used on Cisco routers and multilayer switches connected to
Layer 2 Catalyst switches to perform tasks similar to those performed by IGMP. CGMP is necessary
because the Layer 2 switch cannot distinguish between IP multicast data packets and IGMP report
messages, which are both at the MAC-level and are addressed to the same group address.
client functionality. CGMP is a protocol used on Cisco routers and multilayer switches connected to
Layer 2 Catalyst switches to perform tasks similar to those performed by IGMP. CGMP is necessary
because the Layer 2 switch cannot distinguish between IP multicast data packets and IGMP report
messages, which are both at the MAC-level and are addressed to the same group address.
Beginning in privileged EXEC mode, follow these steps to enable the CGMP server on the switch
interface. This procedure is optional.
interface. This procedure is optional.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Specify the interface to be configured, and enter interface configuration
mode.
mode.
Step 3
ip igmp static-group group-address
Configure the switch as a statically connected member of a group.
By default, this feature is disabled.
Step 4
end
Return to privileged EXEC mode.
Step 5
show ip igmp interface [interface-id]
Verify your entries.
Step 6
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Specify the interface that is connected to the Layer 2 Catalyst switch, and
enter interface configuration mode.
enter interface configuration mode.