Cisco Systems 3130 User Manual

Page of 1226
 
44-38
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 44      Configuring IP Multicast Routing
Configuring Optional Multicast Routing Features
Enabling sdr Listener Support
By default, the switch does not listen to session directory advertisements.
Beginning in privileged EXEC mode, follow these steps to enable the switch to join the default session 
directory group (224.2.127.254) on the interface and listen to session directory advertisements. This 
procedure is optional.
To disable sdr support, use the no ip sdr listen interface configuration command.
Limiting How Long an sdr Cache Entry Exists
By default, entries are never deleted from the sdr cache. You can limit how long the entry remains active 
so that if a source stops advertising SAP information, old advertisements are not needlessly kept.
Beginning in privileged EXEC mode, follow these steps to limit how long an sdr cache entry stays active 
in the cache. This procedure is optional.
To return to the default setting, use the no ip sdr cache-timeout global configuration command. To 
delete the entire cache, use the clear ip sdr privileged EXEC command.
To display the session directory cache, use the show ip sdr privileged EXEC command.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Specify the interface to be enabled for sdr, and enter interface 
configuration mode.
Step 3
ip sdr listen
Enable sdr listener support.
Step 4
end
Return to privileged EXEC mode.
Step 5
show running-config
Verify your entries.
Step 6
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ip sdr cache-timeout minutes
Limit how long an sdr cache entry stays active in the cache.
By default, entries are never deleted from the cache.
For minutes, the range is 1 to 4294967295.
Step 3
end
Return to privileged EXEC mode.
Step 4
show running-config
Verify your entries.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.