Cisco Systems 3130 User Manual

Page of 1226
 
5-24
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 5      Managing Switch Stacks
Configuring the Switch Stack
Beginning in privileged EXEC mode, follow these steps to assign a priority value to a stack member: 
This procedure is optional.
Provisioning a New Member for a Switch Stack
Note
This task is available only from the stack master.
Beginning in privileged EXEC mode, follow these steps to provision a new member for a switch stack. 
This procedure is optional.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
switch stack-member-number priority 
new-priority-number
Specify the stack member number and the new priority for the stack 
member. The stack member number range is 1 to 9. The priority value 
range is 1 to 15.
You can display the current priority value by using the show switch user 
EXEC command. 
The new priority value takes effect immediately but does not affect the 
current stack master. The new priority value helps determine which stack 
member is elected as the new stack master when the current stack master 
or switch stack resets.
Step 3
end
Return to privileged EXEC mode.
Step 4
reload slot stack-member-number
Reset the stack member, and apply this configuration change.
Step 5
show switch stack-member-number
Verify the stack member priority value.
Step 6
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Step 1
show switch
Display summary information about the switch stack.
Step 2
configure terminal
Enter global configuration mode.
Step 3
switch stack-member-number provision 
type 
Specify the stack member number for the preconfigured switch. By 
default, no switches are provisioned.
For stack-member-number, the range is 1 to 9. Specify a stack member 
number that is not already used in the switch stack. See Step 1.
For type, enter the model number of a supported switch that is listed in 
the command-line help strings. 
Step 4
end
Return to privileged EXEC mode.
Step 5
show running-config
Verify the correct numbering of interfaces in the running configuration 
file.
Step 6
show switch stack-member-number
Verify the status of the provisioned switch. For stack-member-number
enter the same number as in Step 1.
Step 7
copy running-config startup-config
(Optional) Save your entries in the configuration file.