Cisco Systems 3130 User Manual

Page of 1226
 
5-25
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 5      Managing Switch Stacks
Accessing the CLI of a Specific Stack Member
To remove provisioned information and to avoid receiving an error message, remove the specified switch 
from the stack before you use the no form of this command.
For example, if you are removing a provisioned switch in a stack with this configuration:
The stack has four members
Stack member 1 is the master
Stack member 3 is a provisioned switch
and want to remove the provisioned information and to avoid receiving an error message, you can remove 
power from stack member 3, disconnect the StackWise Plus cables between the stack member 3 and 
switches to which it is connected, reconnect the cables between the remaining stack members, and enter 
the no switch stack-member-number provision global configuration command. 
This example shows how to provision a switch with a stack member number of 2 for the switch stack. 
The show running-config command output shows the interfaces associated with the provisioned switch:
Switch(config)# switch 2 provision WS-CBS3130G-S
Switch(config)# end
Switch# show running-config | include switch 2
!
interface GigabitEthernet2/0/1
!
interface GigabitEthernet2/0/2
!
interface GigabitEthernet2/0/3
<output truncated>
Accessing the CLI of a Specific Stack Member
Note
This task is available only from the stack master. This task is only for debugging purposes.
You can access all or specific stack members by using the remote command {all | 
stack-member-number} privileged EXEC command. The stack member number range is 1 to 9.
You can access specific stack members by using the session stack-member-number privileged EXEC 
command. The stack member number range is 1 to 9. The stack member number is appended to the 
system prompt. For example, 
Switch-2#
 is the prompt in privileged EXEC mode for stack member 2, 
and the system prompt for the stack master is 
Switch
. Enter exit to return to the CLI session on the stack 
master. Only the show and debug commands are available in a CLI session to a specific stack member.
Displaying Switch Stack Information
To display configuration changes that you save after you reset a specific stack member or the switch 
stack, use the privileged EXEC commands listed in