Cisco Systems 3130 User Manual

Page of 1226
 
17-8
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 17      Configuring STP
Understanding Spanning-Tree Features
How a Switch or Port Becomes the Root Switch or Root Port
If all switches in a network are enabled with default spanning-tree settings, the switch with the lowest 
MAC address becomes the root switch. In 
, Switch A is elected as the root switch because 
the switch priority of all the switches is set to the default (32768) and Switch A has the lowest MAC 
address. However, because of traffic patterns, number of forwarding interfaces, or link types, Switch A 
might not be the ideal root switch. By increasing the priority (lowering the numerical value) of the ideal 
switch so that it becomes the root switch, you force a spanning-tree recalculation to form a new topology 
with the ideal switch as the root.
Figure 17-3
Spanning-Tree Topology
When the spanning-tree topology is calculated based on default parameters, the path between source and 
destination end stations in a switched network might not be ideal. For instance, connecting higher-speed 
links to an interface that has a higher number than the root port can cause a root-port change. The goal 
is to make the fastest link the root port.
For example, assume that one port on Switch B is a Gigabit Ethernet link and that another port on 
Switch B (a 10/100 link) is the root port. Network traffic might be more efficient over the Gigabit 
Ethernet link. By changing the spanning-tree port priority on the Gigabit Ethernet port to a higher 
priority (lower numerical value) than the root port, the Gigabit Ethernet port becomes the new root port. 
Spanning Tree and Redundant Connectivity
You can create a redundant backbone with spanning tree by connecting two switch interfaces to another 
device or to two different devices, as shown in 
. Spanning tree automatically disables one 
interface but enables it if the other one fails. If one link is high-speed and the other is low-speed, the 
low-speed link is always disabled. If the speeds are the same, the port priority and port ID are added 
together, and spanning tree disables the link with the lowest value.
86475
DP
DP
RP
DP
RP
DP
RP = Root Port
DP = Designated Port
DP
RP
D
A
C
B