Cisco Systems 3130 User Manual

Page of 1226
 
17-15
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 17      Configuring STP
Configuring Spanning-Tree Features
Changing the Spanning-Tree Mode.
The switch supports three spanning-tree modes: PVST+, rapid PVST+, or MSTP. By default, the switch 
runs the PVST+ protocol.
Beginning in privileged EXEC mode, follow these steps to change the spanning-tree mode. If you want 
to enable a mode that is different from the default mode, this procedure is required.
To return to the default setting, use the no spanning-tree mode global configuration command. To return 
the port to its default setting, use the no spanning-tree link-type interface configuration command.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
spanning-tree mode {pvst mst | 
rapid-pvst}
Configure a spanning-tree mode. All stack members run the same 
version of spanning-tree.
Select pvst to enable PVST+ (the default setting).
Select mst to enable MSTP (and RSTP). For more configuration 
steps, see 
Select rapid-pvst to enable rapid PVST+.
Step 3
interface interface-id
(Recommended for rapid-PVST+ mode only) Specify an interface to 
configure, and enter interface configuration mode. Valid interfaces 
include physical ports, VLANs, and port channels. The VLAN ID range 
is 1 to 4094. The port-channel range is 1 to 48.
Step 4
spanning-tree link-type point-to-point
(Recommended for rapid-PVST+ mode only) Specify that the link type 
for this port is point-to-point. 
If you connect this port (local port) to a remote port through a 
point-to-point link and the local port becomes a designated port, the 
switch negotiates with the remote port and rapidly changes the local 
port to the forwarding state.
Step 5
end
Return to privileged EXEC mode.
Step 6
clear spanning-tree detected-protocols
(Recommended for rapid-PVST+ mode only) If any port on the switch 
is connected to a port on a legacy IEEE 802.1D switch, restart the 
protocol migration process on the entire switch.
This step is optional if the designated switch detects that this switch is 
running rapid PVST+.
Step 7
show spanning-tree summary
and
show spanning-tree interface 
interface-id
Verify your entries.
Step 8
copy running-config startup-config
(Optional) Save your entries in the configuration file.