Cisco Systems 3130 User Manual

Page of 1226
 
18-15
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 18      Configuring MSTP
Configuring MSTP Features
Default MSTP Configuration
 shows the default MSTP configuration.
For information about the supported number of spanning-tree instances, see the 
.
MSTP Configuration Guidelines
These are the configuration guidelines for MSTP:
When you enable MST by using the spanning-tree mode mst global configuration command, RSTP 
is automatically enabled.
For two or more standalone switches to be in the same MST region, they must have the same 
VLAN-to-instance map, the same configuration revision number, and the same name.
For two or more stacked switches to be in the same MST region, they must have the same 
VLAN-to-instance map, the same configuration revision number, and the same name.
The standalone switch supports up to 65 MST instances. The number of VLANs that can be mapped 
to a particular MST instance is unlimited.
The switch stack supports up to 65 MST instances. The number of VLANs that can be mapped to a 
particular MST instance is unlimited.
PVST+, rapid PVST+, and MSTP are supported, but only one version can be active at any time. (For 
example, all VLANs run PVST+, all VLANs run rapid PVST+, or all VLANs run MSTP.) For more 
information, see the 
. For information on the recommended trunk port configuration, see the 
All stack members run the same version of spanning tree (all PVST+, rapid PVST+, or MSTP). For 
more information, see the 
Table 18-4
Default MSTP Configuration
Feature
Default Setting
Spanning-tree mode
PVST+ (Rapid PVST+ and MSTP are disabled).
Switch priority (configurable on a per-CIST port basis)
32768.
Spanning-tree port priority (configurable on a per-CIST port basis) 
128.
Spanning-tree port cost (configurable on a per-CIST port basis) 
1000 Mb/s: 4.
100 Mb/s: 19.
10 Mb/s: 100.
Hello time
2 seconds.
Forward-delay time
15 seconds.
Maximum-aging time
20 seconds.
Maximum hop count
20 hops.