Cisco Systems 3130 User Manual

Page of 1226
 
18-19
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 18      Configuring MSTP
Configuring MSTP Features
To return the switch to its default setting, use the no spanning-tree mst instance-id root global 
configuration command.
Configuring a Secondary Root Switch
When you configure a switch with the extended system ID support as the secondary root, the switch 
priority is modified from the default value (32768) to 28672. The switch is then likely to become the root 
switch for the specified instance if the primary root switch fails. This is assuming that the other network 
switches use the default switch priority of 32768 and therefore are unlikely to become the root switch.
You can execute this command on more than one switch to configure multiple backup root switches. Use 
the same network diameter and hello-time values that you used when you configured the primary root 
switch with the spanning-tree mst instance-id root primary global configuration command.
Beginning in privileged EXEC mode, follow these steps to configure a switch as the secondary root 
switch. This procedure is optional.
To return the switch to its default setting, use the no spanning-tree mst instance-id root global 
configuration command.
Step 4
show spanning-tree mst instance-id
Verify your entries.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
spanning-tree mst instance-id root 
secondary
 [diameter net-diameter 
[hello-time seconds]] 
Configure a switch as the secondary root switch. 
For instance-id, you can specify a single instance, a range of 
instances separated by a hyphen, or a series of instances 
separated by a comma. The range is 0 to 4094.
(Optional) For diameter net-diameter, specify the maximum 
number of switches between any two end stations. The range is 2 
to 7. This keyword is available only for MST instance 0.
(Optional) For hello-time seconds, specify the interval in 
seconds between the generation of configuration messages by 
the root switch. The range is 1 to 10 seconds; the default 
is 2 seconds.
Use the same network diameter and hello-time values that you used 
when configuring the primary root switch. See the 
Step 3
end
Return to privileged EXEC mode.
Step 4
show spanning-tree mst instance-id
Verify your entries.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.