Cisco Systems 3130 User Manual

Page of 1226
 
20-2
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 20      Configuring Flex Links and the MAC Address-Table Move Update Feature
Understanding Flex Links and the MAC Address-Table Move Update
You configure Flex Links on one Layer 2 interface (the active link) by assigning another Layer 2 
interface as the Flex Link or backup link. The Flex Link can be on the same switch or on another switch 
in the stack. When one of the links is up and forwarding traffic, the other link is in standby mode, ready 
to begin forwarding traffic if the other link shuts down. At any given time, only one of the interfaces is 
in the linkup state and forwarding traffic. If the primary link shuts down, the standby link starts 
forwarding traffic. When the active link comes back up, it goes into standby mode and does not forward 
traffic. STP is disabled on Flex Link interfaces.
In 
, ports 1 and 2 on switch A are connected to uplink switches B and C. Because they are 
configured as Flex Links, only one of the interfaces is forwarding traffic; the other is in standby mode. 
If port 1 is the active link, it begins forwarding traffic between port 1 and switch B; the link between 
port 2 (the backup link) and switch C is not forwarding traffic. If port 1 goes down, port 2 comes up and 
starts forwarding traffic to switch C. When port 1 comes back up, it goes into standby mode and does 
not forward traffic; port 2 continues forwarding traffic. 
You can also choose to configure a preemption mechanism, specifying the preferred port for forwarding 
traffic. For example, in the example in 
you can configure the Flex Links pair with 
preemption mode. In the scenario shown, when port 1 comes back up and has more bandwidth than 
port 2, port 1 begins forwarding traffic after 60 seconds. Port 2 becomes the standby port. You do this 
by entering the interface configuration switchport backup interface preemption mode bandwidth and 
switchport backup interface preemption delay commands.
Figure 20-1
Flex Links Configuration Example
If a primary (forwarding) link goes down, a trap notifies the network management stations. If the standby 
link goes down, a trap notifies the users.
Flex Links are supported only on Layer 2 ports and port channels, not on VLANs or on Layer 3 ports. 
VLAN Flex Link Load Balancing and Support
VLAN Flex Link load-balancing allows users to configure a Flex Link pair so that both ports 
simultaneously forward the traffic for some mutually exclusive VLANs. For example, if Flex Link ports 
are configured for 1-100 VLANs, the traffic of the first 50 VLANs can be forwarded on one port and the 
rest on the other port. If one of the ports fail, the other active port forwards all the traffic. When the failed 
port comes back up, it resumes forwarding traffic in the preferred VLANs. This way, apart from 
providing the redundancy, this Flex Link pair can be used for load balancing. Also, Flex Link VLAN 
load-balancing does not impose any restrictions on uplink switches.
Switch A
Uplink
switch B
Port 1
Port 2
Uplink
switch C
116082