Cisco Systems 3130 User Manual
C H A P T E R
22-1
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
22
Configuring Dynamic ARP Inspection
This chapter describes how to configure dynamic Address Resolution Protocol inspection (dynamic ARP
inspection) on the switch. This feature helps prevent malicious attacks on the switch by not relaying
invalid ARP requests and responses to other ports in the same VLAN. Unless otherwise noted, the term
switch refers to a standalone switch and to a switch stack.
inspection) on the switch. This feature helps prevent malicious attacks on the switch by not relaying
invalid ARP requests and responses to other ports in the same VLAN. Unless otherwise noted, the term
switch refers to a standalone switch and to a switch stack.
Note
For complete syntax and usage information for the commands used in this chapter, see the command
reference for this release.
reference for this release.
This chapter consists of these sections:
•
•
•
Understanding Dynamic ARP Inspection
ARP provides IP communication within a Layer 2 broadcast domain by mapping an IP address to a MAC
address. For example, Host B wants to send information to Host A but does not have the MAC address
of Host A in its ARP cache. Host B generates a broadcast message for all hosts within the broadcast
domain to obtain the MAC address associated with the IP address of Host A. All hosts within the
broadcast domain receive the ARP request, and Host A responds with its MAC address. However,
because ARP allows a gratuitous reply from a host even if an ARP request was not received, an ARP
spoofing attack and the poisoning of ARP caches can occur. After the attack, all traffic from the device
under attack flows through the attacker’s computer and then to the router, switch, or host.
address. For example, Host B wants to send information to Host A but does not have the MAC address
of Host A in its ARP cache. Host B generates a broadcast message for all hosts within the broadcast
domain to obtain the MAC address associated with the IP address of Host A. All hosts within the
broadcast domain receive the ARP request, and Host A responds with its MAC address. However,
because ARP allows a gratuitous reply from a host even if an ARP request was not received, an ARP
spoofing attack and the poisoning of ARP caches can occur. After the attack, all traffic from the device
under attack flows through the attacker’s computer and then to the router, switch, or host.
A malicious user can attack hosts, switches, and routers connected to your Layer 2 network by poisoning
the ARP caches of systems connected to the subnet and by intercepting traffic intended for other hosts
on the subnet.
the ARP caches of systems connected to the subnet and by intercepting traffic intended for other hosts
on the subnet.
shows an example of ARP cache poisoning.