Cisco Systems 3130 User Manual
26-4
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 26 Configuring CDP
Configuring CDP
Disabling and Enabling CDP on an Interface
CDP is enabled by default on all supported interfaces to send and to receive CDP information.
Beginning in privileged EXEC mode, follow these steps to disable CDP on a port:
Beginning in privileged EXEC mode, follow these steps to enable CDP on a port when it has been
disabled:
disabled:
This example shows how to enable CDP on a port when it has been disabled.
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# cdp enable
Switch(config-if)# end
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Specify the interface on which you are disabling CDP, and enter
interface configuration mode.
interface configuration mode.
Step 3
no cdp enable
Disable CDP on the interface.
Step 4
end
Return to privileged EXEC mode.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Specify the interface on which you are enabling CDP, and enter
interface configuration mode.
interface configuration mode.
Step 3
cdp enable
Enable CDP on the interface after disabling it.
Step 4
end
Return to privileged EXEC mode.
Step 5
copy running-config startup-config
(Optional) Save your entries in the configuration file.