Cisco Systems 3130 User Manual

Page of 1226
 
29-12
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 29      Configuring SPAN and RSPAN
Configuring SPAN and RSPAN
You can limit SPAN traffic to specific VLANs by using the filter vlan keyword. If a trunk port is 
being monitored, only traffic on the VLANs specified with this keyword is monitored. By default, 
all VLANs are monitored on a trunk port.
You cannot mix source VLANs and filter VLANs within a single SPAN session.
Creating a Local SPAN Session
Beginning in privileged EXEC mode, follow these steps to create a SPAN session and specify the source 
(monitored) ports or VLANs and the destination (monitoring) ports:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
no monitor session {session_number | all | 
local | remote}
Remove any existing SPAN configuration for the session.
For session_number, the range is 1 to 66.
Specify all to remove all SPAN sessions, local to remove all local 
sessions, or remote to remove all remote SPAN sessions.
Step 3
monitor session session_number source 
{interface interface-id | vlan vlan-id} [, | -
[both | rx | tx]
Specify the SPAN session and the source port (monitored port).
For session_number, the range is 1 to 66.
For interface-id, specify the source port or source VLAN to monitor.
For source interface-id, specify the source port to monitor. Valid 
interfaces include physical interfaces and port-channel logical 
interfaces (port-channel port-channel-number). Valid 
port-channel numbers are 1 to 48.
For vlan-id, specify the source VLAN to monitor. The range is 1 
to 4094 (excluding the RSPAN VLAN). 
Note
A single session can include multiple sources (ports or 
VLANs), defined in a series of commands, but you cannot 
combine source ports and source VLANs in one session.
(Optional) [, | -] Specify a series or range of interfaces. Enter a space 
before and after the comma; enter a space before and after the 
hyphen.
(Optional) Specify the direction of traffic to monitor. If you do not 
specify a traffic direction, the SPAN monitors both sent and received 
traffic.
both—Monitor both received and sent traffic. This is the default.
rx—Monitor received traffic.
tx—Monitor sent traffic.
Note
You can use the monitor session session_number source 
command multiple times to configure multiple source ports.