Cisco Systems 3130 User Manual

Page of 1226
 
34-8
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 34      Configuring Network Security with ACLs
Configuring IPv4 ACLs
Creating Standard and Extended IPv4 ACLs
This section describes IP ACLs. An ACL is a sequential collection of permit and deny conditions. One 
by one, the switch tests packets against the conditions in an access list. The first match determines 
whether the switch accepts or rejects the packet. Because the switch stops testing after the first match, 
the order of the conditions is critical. If no conditions match, the switch denies the packet.
The software supports these types of ACLs or access lists for IPv4:
Standard IP access lists use source addresses for matching operations. 
Extended IP access lists use source and destination addresses for matching operations and optional 
protocol-type information for finer granularity of control.
These sections describe access lists and how to create them:
Access List Numbers
The number you use to denote your ACL shows the type of access list that you are creating. 
lists the access-list number and corresponding access list type and shows whether or not they are 
supported in the switch. The switch supports IPv4 standard and extended access lists, numbers 1 to 199 
and 1300 to 2699.
Table 34-1
Access List Numbers
Access List Number
Type
Supported
1–99
IP standard access list
Yes
100–199
IP extended access list
Yes
200–299
Protocol type-code access list
No
300–399
DECnet access list
No
400–499
XNS standard access list
No
500–599
XNS extended access list
No
600–699
AppleTalk access list
No
700–799
48-bit MAC address access list
No
800–899
IPX standard access list
No
900–999
IPX extended access list
No
1000–1099
IPX SAP access list
No
1100–1199
Extended 48-bit MAC address access list
No