Cisco Systems 3130 User Manual

Page of 1226
 
36-2
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 36      Configuring QoS
Understanding QoS
Understanding QoS
Typically, networks operate on a best-effort delivery basis, which means that all traffic has equal priority 
and an equal chance of being delivered in a timely manner. When congestion occurs, all traffic has an 
equal chance of being dropped.
When you configure the QoS feature, you can select specific network traffic, prioritize it according to 
its relative importance, and use congestion-management and congestion-avoidance techniques to 
provide preferential treatment. Implementing QoS in your network makes network performance more 
predictable and bandwidth utilization more effective.
The QoS implementation is based on the Differentiated Services (Diff-Serv) architecture, an emerging 
standard from the Internet Engineering Task Force (IETF). This architecture specifies that each packet 
is classified upon entry into the network. 
The classification is carried in the IP packet header, using 6 bits from the deprecated IP type of service 
(ToS) field to carry the classification (class) information. Classification can also be carried in the 
Layer 2 frame. These special bits in the Layer 2 frame or a Layer 3 packet are described here and shown 
in 
:
Prioritization bits in Layer 2 frames:
Layer 2 Inter-Switch Link (ISL) frame headers have a 1-byte User field that carries an IEEE 802.1p 
class of service (CoS) value in the three least-significant bits. On ports configured as Layer 2 ISL 
trunks, all traffic is in ISL frames.
Layer 2 802.1Q frame headers have a 2-byte Tag Control Information field that carries the CoS value 
in the three most-significant bits, which are called the User Priority bits. On ports configured as 
Layer 2 802.1Q trunks, all traffic is in 802.1Q frames except for traffic in the native VLAN. 
Other frame types cannot carry Layer 2 CoS values.
Layer 2 CoS values range from 0 for low priority to 7 for high priority.
Prioritization bits in Layer 3 packets: 
Layer 3 IP packets can carry either an IP precedence value or a Differentiated Services Code Point 
(DSCP) value. QoS supports the use of either value because DSCP values are backward-compatible 
with IP precedence values.
IP precedence values range from 0 to 7.
DSCP values range from 0 to 63.
Note
IPv6 QoS is not supported in this release.