Cisco Systems 3130 User Manual

Page of 1226
 
36-28
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 36      Configuring QoS
Configuring Auto-QoS
Note
You should not configure any standard QoS commands before entering the auto-QoS commands. You 
can fine-tune the QoS configuration, but we recommend that you do so only after the auto-QoS 
configuration is completed.
Beginning in privileged EXEC mode, follow these steps to configure the switch at the edge of the QoS 
domain to prioritize the VoIP traffic over all other traffic:
Command
Purpose
Step 1
debug auto qos
Enable debugging for auto-QoS. When debugging is enabled, the 
switch displays the QoS configuration that is automatically 
generated when auto-QoS is enabled.
Step 2
configure terminal
Enter global configuration mode.
Step 3
cdp enable
Enable CDP globally. By default, it is enabled.
Step 4
interface interface-id
Specify the switch port connected to the Cisco IP Phone, and enter 
interface configuration mode.
Step 5
auto qos voip cisco-phone
Enable auto-QoS on the port, and specify that the port is connected 
to a Cisco IP Phone.
The QoS labels of incoming packets are trusted only when the 
Cisco IP Phone is detected.
Step 6
exit
Return to global configuration mode.
Step 7
Repeat Steps 4 to 6 for as many ports as are connected to the Cisco 
IP Phone.
Step 8
interface interface-id
Specify the switch port identified as connected to a trusted switch 
or router, and enter interface configuration mode. See 
Step 9
auto qos voip trust
Enable auto-QoS on the port, and specify that the port is connected 
to a trusted router or switch.
Step 10
end
Return to privileged EXEC mode.
Step 11
show auto qos
Verify your entries.
This command displays the auto-QoS command on the interface 
on which auto-QoS was enabled. You can use the show 
running-config
 privileged EXEC command to display the 
auto-QoS configuration and the user modifications.
For information about the QoS configuration that might be 
affected by auto-QoS, see the “Displaying Auto-QoS Information” 
section on page 26-12.
Step 12
copy running-config 
startup-config
 
Save the auto qos voip interface configuration commands and the 
generated auto-QoS configuration in the configuration file.