Manualsbrain.com
  1. Manuals
  2. Brands
  3. Cisco Systems
  4. 3130
  5. User Manual

Cisco Systems 3130 User Manual

Download
Page of 1226
 
38-21
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 38      Configuring IP Unicast Routing
Configuring RIP
Default RIP Configuration
 shows the default RIP configuration.
Configuring Basic RIP Parameters
To configure RIP, you enable RIP routing for a network and optionally configure other parameters. RIP 
configuration commands are ignored until you configure the network number. 
Beginning in privileged EXEC mode, follow these steps to enable and configure RIP:
Table 38-4
Default RIP Configuration
Feature
Default Setting
Auto summary
Enabled.
Default-information originate
Disabled.
Default metric
Built-in; automatic metric translations.
IP RIP authentication key-chain No authentication.
Authentication mode: clear text.
IP RIP receive version
According to the version router configuration command.
IP RIP send version
According to the version router configuration command.
IP RIP triggered
According to the version router configuration command.
IP split horizon
Varies with media.
Neighbor
None defined.
Network
None specified.
Offset list
Disabled.
Output delay
0 milliseconds.
Timers basic
•
Update: 30 seconds.
•
Invalid: 180 seconds.
•
Hold-down: 180 seconds.
•
Flush: 240 seconds.
Validate-update-source
Enabled.
Version
Receives RIP Version 1 and 2 packets; sends Version 1 packets.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ip routing 
Enable IP routing. (Required only if IP routing is disabled.)
Step 3
router rip
Enable a RIP routing process, and enter router configuration mode.