Cisco Systems 3130 User Manual
38-26
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 38 Configuring IP Unicast Routing
Configuring OSPF
•
Plain text and MD5 authentication among neighboring routers within an area is supported.
•
Configurable routing interface parameters include interface output cost, retransmission interval,
interface transmit delay, router priority, router dead and hello intervals, and authentication key.
interface transmit delay, router priority, router dead and hello intervals, and authentication key.
•
Virtual links are supported.
•
Not-so-stubby-areas (NSSAs) per RFC 1587are supported.
OSPF typically requires coordination among many internal routers, area border routers (ABRs)
connected to multiple areas, and autonomous system boundary routers (ASBRs). The minimum
configuration would use all default parameter values, no authentication, and interfaces assigned to areas.
If you customize your environment, you must ensure coordinated configuration of all routers.
connected to multiple areas, and autonomous system boundary routers (ASBRs). The minimum
configuration would use all default parameter values, no authentication, and interfaces assigned to areas.
If you customize your environment, you must ensure coordinated configuration of all routers.
These sections contain this configuration information:
•
•
•
•
•
•
•
•
Note
To enable OSPF, the switch or stack master must be running the IP services feature set.
Default OSPF Configuration
shows the default OSPF configuration.