Cisco Systems 3130 User Manual

Page of 1226
 
38-40
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 38      Configuring IP Unicast Routing
Configuring EIGRP
EIGRP NSF Capability
The IP-services feature set also supports EIGRP NSF-capable routing for IPv4 for better convergence 
and lower traffic loss following a stack master change. When an EIGRP NSF-capable stack master 
restarts or a new stack master starts up and NSF restarts, the switch has no neighbors, and the topology 
table is empty. The switch must bring up the interfaces, reacquire neighbors, and rebuild the topology 
and routing tables without interrupting the traffic directed toward the switch stack. EIGRP peer routers 
maintain the routes learned from the new stack master and continue forwarding traffic through the NSF 
restart process.
To prevent an adjacency reset by the neighbors, the new stack master uses a new Restart (RS) bit in the 
EIGRP packet header to show the restart. When the neighbor receives this, it synchronizes the stack in 
its peer list and maintains the adjacency with the stack. The neighbor then sends its topology table to the 
stack master with the RS bit set to show that it is NSF-aware and is aiding the new stack master. 
If at least one of the stack peer neighbors is NSF-aware, the stack master receives updates and rebuilds 
its database. Each NSF-aware neighbor sends an end of table (EOT) marker in the last update packet to 
mark the end of the table content. The stack master recognizes the convergence when it receives the EOT 
marker, and it then begins sending updates. When the stack master has received all EOT markers from 
its neighbors or when the NSF converge timer expires, EIGRP notifies the routing information database 
(RIB) of convergence and floods its topology table to all NSF-aware peers.
Note
NSF is not supported on interfaces configured for Hot Standby Router Protocol (HSRP).
Use the nsf EIGRP routing configuration command to enable EIGRP NSF routing. Use the show ip 
protocols 
privileged EXEC command to verify that NSF is enabled on the device. See the command 
reference for this release for information about the nsf command.
Configuring Basic EIGRP Parameters
Beginning in privileged EXEC mode, follow these steps to configure EIGRP. Configuring the routing 
process is required; other steps are optional:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
router eigrp autonomous-system
Enable an EIGRP routing process, and enter router configuration 
mode. The AS number identifies the routes to other EIGRP routers 
and is used to tag routing information.
Step 3
nsf
(Optional) Enable EIGRP NSF. Enter this command on the stack 
master and on all of its peers.
Step 4
network network-number
Associate networks with an EIGRP routing process. EIGRP sends 
updates to the interfaces in the specified networks. 
Step 5
eigrp log-neighbor-changes
(Optional) Enable logging of EIGRP neighbor changes to monitor 
routing system stability.