Cisco Systems 3130 User Manual

Page of 1226
 
38-42
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 38      Configuring IP Unicast Routing
Configuring EIGRP
Use the no forms of these commands to disable the feature or return the setting to the default value.
Configuring EIGRP Route Authentication
EIGRP route authentication provides MD5 authentication of routing updates from the EIGRP routing 
protocol to prevent the introduction of unauthorized or false routing messages from unapproved sources.
Beginning in privileged EXEC mode, follow these steps to enable authentication:
Step 5
ip hello-interval eigrp autonomous-system-number 
seconds
(Optional) Change the hello time interval for an EIGRP 
routing process. The range is 1 to 65535 seconds. The 
default is 60 seconds for low-speed NBMA networks and 5 
seconds for all other networks.
Step 6
ip hold-time eigrp autonomous-system-number 
seconds
(Optional) Change the hold time interval for an EIGRP 
routing process. The range is 1 to 65535 seconds. The 
default is 180 seconds for low-speed NBMA networks and 
15 seconds for all other networks.
Caution
Do not adjust the hold time without consulting 
Cisco technical support.
Step 7
no ip split-horizon eigrp autonomous-system-number  (Optional) Disable split horizon to allow route information 
to be advertised by a router out any interface from which that 
information originated. 
Step 8
end 
Return to privileged EXEC mode.
Step 9
show ip eigrp interface
Display which interfaces EIGRP is active on and 
information about EIGRP relating to those interfaces.
Step 10
copy running-config startup-config 
(Optional) Save your entries in the configuration file.
Command
Purpose
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface interface-id
Enter interface configuration mode, and specify the 
Layer 3 interface to configure.
Step 3
ip authentication mode eigrp autonomous-system md5
Enable MD5 authentication in IP EIGRP packets.
Step 4
ip authentication key-chain eigrp autonomous-system 
key-chain
Enable authentication of IP EIGRP packets.
Step 5
exit
Return to global configuration mode.
Step 6
key chain name-of-chain
Identify a key chain and enter key-chain configuration 
mode. Match the name configured in Step 4.
Step 7
key number
In key-chain configuration mode, identify the key 
number.
Step 8
key-string text
In key-chain key configuration mode, identify the key 
string.