Cisco Systems 3130 User Manual

Page of 1226
 
38-54
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 38      Configuring IP Unicast Routing
Configuring BGP
Beginning in privileged EXEC mode, follow these steps to configure some decision attributes:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
router bgp autonomous-system
Enable a BGP routing process, assign it an AS number, 
and enter router configuration mode.
Step 3
bgp best-path as-path ignore
(Optional) Configure the router to ignore AS path length 
in selecting a route.
Step 4
neighbor {ip-address peer-group-name} next-hop-self (Optional) Disable next-hop processing on BGP updates 
to a neighbor by entering a specific IP address to be used 
instead of the next-hop address.
Step 5
neighbor {ip-address peer-group-name} weight 
weight
(Optional) Assign a weight to a neighbor connection. 
Acceptable values are from 0 to 65535; the largest weight 
is the preferred route. Routes learned through another 
BGP peer have a default weight of 0; routes sourced by the 
local router have a default weight of 32768.
Step 6
default-metric number 
(Optional) Set a MED metric to set preferred paths to 
external neighbors. All routes without a MED will also be 
set to this value. The range is 1 to 4294967295. The lowest 
value is the most desirable.
Step 7
bgp bestpath med missing-as-worst 
(Optional) Configure the switch to consider a missing 
MED as having a value of infinity, making the path 
without a MED value the least desirable path.
Step 8
bgp always-compare med 
(Optional) Configure the switch to compare MEDs for 
paths from neighbors in different autonomous systems. By 
default, MED comparison is only done among paths in the 
same AS.
Step 9
bgp bestpath med confed
(Optional) Configure the switch to consider the MED in 
choosing a path from among those advertised by different 
subautonomous systems within a confederation.
Step 10
bgp deterministic med 
(Optional) Configure the switch to consider the MED 
variable when choosing among routes advertised by 
different peers in the same AS.
Step 11
bgp default local-preference value
(Optional) Change the default local preference value. The 
range is 0 to 4294967295; the default value is 100. The 
highest local preference value is preferred.
Step 12
maximum-paths number
(Optional) Configure the number of paths to be added to 
the IP routing table. The default is to only enter the best 
path in the routing table. The range is from 1 to 16. Having 
multiple paths allows load-balancing among the paths. 
(Although the switch software allows a maximum of 
32 equal-cost routes, the switch hardware will never use 
more than 16 paths per route.)
Step 13
end 
Return to privileged EXEC mode.