Cisco Systems 3130 User Manual

Page of 1226
 
38-91
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 38      Configuring IP Unicast Routing
Configuring Protocol-Independent Features
Beginning in privileged EXEC mode, follow these steps to configure PBR:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
route-map map-tag [permit] [sequence number]
Define any route maps used to control where packets are 
output, and enter route-map configuration mode.
map-tag—A meaningful name for the route map. The ip 
policy route-map 
interface configuration command uses 
this name to reference the route map. Multiple route maps 
might share the same map tag name.
(Optional) If permit is specified and the match criteria 
are met for this route map, the route is policy-routed as 
controlled by the set actions. 
Note
The route-map deny statement is not supported in 
PBR route maps to be applied to an interface.
sequence number (Optional)— Number that shows the 
position of a new route map in the list of route maps 
already configured with the same name.
Step 3
match ip address {access-list-number | 
access-list-name
} [...access-list-number 
...access-list-name]
Match the source and destination IP address that is permitted 
by one or more standard or extended access lists.
Note
Do not enter an ACL with a deny ACE or an ACL that 
permits a packet destined for a local address.
If you do not specify a match command, the route map applies 
to all packets.
Step 4
set ip next-hop ip-address [...ip-address]
Specify the action to take on the packets that match the 
criteria. Set next hop to which to route the packet (the next hop 
must be adjacent).
Step 5
exit
Return to global configuration mode.
Step 6
interface interface-id
Enter interface configuration mode, and specify the interface 
to configure.
Step 7
ip policy route-map map-tag
Enable PBR on a Layer 3 interface, and identify the route map 
to use. You can configure only one route map on an interface. 
However, you can have multiple route map entries with 
different sequence numbers. These entries are evaluated in 
sequence number order until the first match. If there is no 
match, packets are routed as usual.
Note
If the IP policy route map contains a deny statement, 
the configuration fails.
Step 8
ip route-cache policy
(Optional) Enable fast-switching PBR. You must first enable 
PBR before enabling fast-switching PBR.
Step 9
exit
Return to global configuration mode.
Step 10
ip local policy route-map map-tag
(Optional) Enable local PBR to perform policy-based routing 
on packets originating at the switch. This applies to packets 
generated by the switch and not to incoming packets.